![]() ![]() You can see the valid address in the serial Monitor. sketch to increase the address value until it can read a temperature. In this tutorial, we’ll discuss what the I2C communication protocol is, how it works, and how to use it on the Arduino. I was fighting also with hte address of the device as i could not find the value in the (online) datasheet. It says the device has an EEPROM and that in order to read out the correct humidity, 4 calibration factors need to be read out from the EEPROM at address of 10 and 11,12 and 13 for sensitivity, offset. If (Wire.available()) rv = rv * 256 + Wire.receive() Int readCalib( int deviceaddress, int calibAddress ) // deviceaddress is 1 according to datasheet Installing is done directly in the IDE, and is a quick and easy operation. Without the package, you can simply not use your board. Install your board - this means installing the right 'package' for your board. * It contains a M24C02BN6 Eeprom with calibration values. To upload code to an Arduino board using the IDE, one typically does the following: 1. ![]() I keep getting nothing but zeroes back from the sensor. ![]() Just tried using an HH10D humidity sensor. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |